Page 1 of 1
Need MSQ for a turbocharged 4 Cylinder.. around 2.3L
Posted: Wed Mar 08, 2006 8:16 pm
by Bossman
I want to see a good running turbo 2+litre 4 cylinder VE table.
I want to see how much higher than 100% VE is needed.
Posted: Wed Mar 08, 2006 9:00 pm
by natesully
Not very much, if your ReqFuel is set right. Mine goes to ~110%, and that's ultra rich. You should set your VE map up in the 120's around whatever you call high boost, and go from there. I used the map generator at first, and it worked really well- everything was too rich, so all I had to do was lean it out a little.
Posted: Wed Mar 08, 2006 10:07 pm
by Skiericski
This is a 2.6l 8V MPI engine(mitsubishi) I've only run it up to around 15 PSI so far, but it's pretty solid at around 11.5:1. My VE barely goes above 100.
Posted: Thu Mar 09, 2006 10:12 pm
by Bossman
I would like to thank both you guys for your help. Very informative.