question about injector

Seth23 · Post by **Seth23** » Tue May 16, 2006 1:54 pm

hi, exept for the flow rate and that they are fitting in the hole, there is only 2 kind of injectors?(low and high impedance) so it doesn't matter where they do come from, i just have to know if they are low or high impedance and have the right flow rate?

turbo355 · Post by **turbo355** » Tue May 16, 2006 11:19 pm

You got it. You can check the resistance with a ohm meter to find out the impedence of the injector butt the flow rate is a little harder unless you know what they came out of or if you buy them new.

Seth23 · Post by **Seth23** » Wed May 17, 2006 10:05 am

nice, thx you very much