Ok guys I am starting my wonderful adventure with MSnS-E. It's based off the MS I 2.2 and I have no clue where to start looking for a basic tune setup so I can get my motor to start and begin tuning. I'm sure theres some place here I have over looked. Any help pointing me in the right direction would be great.
If I get a base map and the car idles ok and runs ok can I use the auto tune function and go from there? What type of #'s am I looking for on the guages. It's an Audi 4cyl JN motor with 9.5:1 compression. What are the main guages to pay the most attention to when tuning. I'm use to CIS Basic and have never delt with EFI before. First time for everything though I guess.
Complete Noob Where to start?
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Socialoutcast
- MegaSquirt Newbie
- Posts: 2
- Joined: Thu Nov 17, 2005 11:17 pm
- Location: Beaverton, Oregon, USA
-
Bernard Fife
- Super Squirter
- Posts: 1009
- Joined: Mon Feb 16, 2004 3:15 pm
Socialoutcast,
Start with the tuning section of the manual for MS-II here: http://www.megamanual.com/ms2/tune.htm
Lance.
Start with the tuning section of the manual for MS-II here: http://www.megamanual.com/ms2/tune.htm
Lance.