Page 1 of 1
Looking for close set up......
Posted: Sun Jun 18, 2006 5:20 pm
by QuarterHorse
Just seeing if anybody had a similar engine size set up, I'm running spark and fuel, and was wanting a file to get me close to get started.
351 c.i.
Ported box upper ported GT 40 lower
36lb injectors
.520/.560 lift .226/.236 dur. @ .050 114 lobe sep.
Ported GT40 heads
Long tubes full 2 1/2 in exhaust
75mm T/B
MSD
Electric fan
I'm pretty sure that's about the gist of it.
Thanks in advance.
Posted: Mon Jun 19, 2006 11:03 am
by QuarterHorse
Okay how 'bout semi close haha.
Posted: Wed Jun 21, 2006 3:40 pm
by QuarterHorse
I know there are few windsor powered 'squirted vehicles out there!
Posted: Wed Jun 21, 2006 8:12 pm
by kg6dxn
Try this one, can't hurt
383ci, 36lb injector, .484" lift 284 dur. Edelbrock heads, dual 65mm throttle bodies. Worth a shot?
MSnS-e 29q code
MSI V3.0
Posted: Thu Jun 22, 2006 4:59 pm
by QuarterHorse
Is there a way I can just look at your VE table? Perhaps fuel enrichments as well? I'm using a different version of megatune than this. Perhaps like a screen print of your VE tables and enrichment would be awsome.
Thanks,
Dustin
Posted: Thu Jun 22, 2006 5:00 pm
by QuarterHorse
A screen print say like this, but of the fuel table instead.
Posted: Sat Jun 24, 2006 12:02 pm
by chicksdigwagons
The file he sent, the .vex file, contains the information that you need. Just open it in notepad. If you're still using 8x8 tables you're going to have to do some guestimating to convert his 12x12 down to yours.
Posted: Sat Jun 24, 2006 12:12 pm
by QuarterHorse
Well I was using a 12x12 but somthing happend recently that I'm not sure of and now it's 8x8.
Thanks
Posted: Sun Jun 25, 2006 4:37 pm
by kg6dxn
I can't figure out how to do a screen print. When I veiw my tale all it will let me do is modify bins or close screen. So how do I do it?
Posted: Sun Jun 25, 2006 4:53 pm
by QuarterHorse
I'ts not a problem, I got it off of your file, thanks though!