Page 1 of 2
MS-II Beta
Posted: Wed Jun 21, 2006 1:46 pm
by wmahaffey
Lance,
My I have access to the Beta Forum? I would like to try 2.672.
Are there issues with Main Board Ver 2.2?
I have not finished my Ver 3.0 Main board.
Thanks,
Bill
Posted: Wed Jun 21, 2006 2:24 pm
by Bernard Fife
Bill,
I have added you to the beta forum. If I was you, I'd wait a few hours for the V2.683 code Al will announce. It has a number of fixes, and will save you from loading the code twice.
Lance.
Posted: Wed Jun 21, 2006 5:54 pm
by wmahaffey
I will and thank you.
Bill
Posted: Thu Jun 22, 2006 6:10 am
by johnc32779
Lance, would you also add me to the Beta list.
At this time I have completed the installation of my MS system and was planning to begin serious tuning this morning. However, since 2.683 is to be released momentarily, perhaps I should do something else this morning.
My basic configuration is MS version 3 with MSII, Innovate WB02, MSD, Bosch TPS, VR, and ISC. The engine is a 1989 BMW 3.5 liter M30 engine with it's OEM engine wiring harness installed in a 1971 BMW E3 sedan. A gutted Motronic ECU is used as the interface adapter between the OEM wiring harness and MS, and contains the interface electronics. If necessary, the OEM Motronic system can be reinstalled within minutes.
At this point everything seems to be working exactly as planned. It starts, idles, and drives reasonably well considering tuning has just begun.
Regards, johnc
Posted: Thu Jun 22, 2006 6:18 am
by Bernard Fife
John,
Done!
Lance.
Posted: Thu Jun 22, 2006 8:13 am
by daniel505gti
Lance I would Love to try the beta code to.
Do you mind adding another?
Posted: Thu Jun 22, 2006 8:22 am
by Bernard Fife
Do you mind adding another?
daniel505gti,
I sure don't, it has been done!
Lance.
Can I be added too, please?
Posted: Sun Jun 25, 2006 7:32 am
by synackack
I'm tearing down a BMW 2002, with M10 engine. I'm really interested in utilizing the various crank pulley / 60-2 rings available for the engine (manufacturered to drive Electromotive kits for dis ignition on carb engines)
I had the engine converted to L-Jetronic ECU, I want ignition/spark as I plan on implementing a turbo on the engine. 12x12 fuel map is pretty important to me.
Posted: Sun Jun 25, 2006 9:50 pm
by teg
Hello!
I would also want to join beta forum. I have an engine with siamese ports (opel kadett).
New Code
Posted: Mon Jun 26, 2006 12:29 am
by Timmerklits
Hello,
When will the new code will be availible for everyone.
Greetz Nick