should ign signal wire braiding be grounded?

lani16 · Post by **lani16** » Sun Jul 16, 2006 8:32 pm

MS II V3 Mt 2.5 My question is if i should ground the braided part of my ignition signal wire. This is the shielded type of wire and has a layer of braiding to it (looks like an antenna wire). I ask because i opened my relay board to ecu connector from DIY Autotune and noticed that the wire is soldered to a pin in the connector and so is the braiding inside of it and i'm pretty sure is going to a ground on the connector. Should i ground that wire to the engine somewhere and on the reay board to avoid any unwanted signals going trought it? again thanxxx a lot 4 ur help guys

PSIG · Post by **PSIG** » Mon Jul 17, 2006 12:50 pm

Shielding functions properly only if grounded and on one end only. Works great if you ground it to the mutual MS ground point.

lani16 · Post by **lani16** » Mon Jul 17, 2006 8:26 pm

I see now. Thanxx a lot

mops · Post by **mops** » Tue Jul 18, 2006 1:06 pm

PSIG wrote:Shielding functions properly only if grounded and on one end only. Works great if you ground it to the mutual MS ground point.

second that !
I rerun my vr cable and now my shielding goes up to the actual db37pins. works great !