Page 1 of 1
over-sized throttle bore diameter
Posted: Sat Jul 22, 2006 7:24 pm
by maztah
what problems will I have if I use a much larger throttle body?
Posted: Sun Jul 23, 2006 9:04 am
by cmonref
Have you looked at -- well -- "Throttle Bodies" under "Injectors and Fuel Supplies" on the Manual page.
Look at:
http://www.megamanual.com/v22manual/minj.htm#throttle
Posted: Sun Jul 23, 2006 8:00 pm
by TV Super Bee
I run dual 65mm throttle bodies. With a large throttle body you will have large rpm gains with little throttle movement. I had trouble useing map enrich because of the "air dump" into the engine. My solution was to use alpha-n with a low v/s setting, my lowest is 0.7v/s with a 0.6ms squirt. I then doubled the value for the next bin, then doubled the value again and so on. This gave me a good starting point to tune the accel enrich. remenber v/s is volts per second of how fast you open the throttle. With a large TB you will not have to open very fast at all to make fast rpm gains. My setup is guiet driveable, no stumbles or surging.