Megatune flashes an RPM value once and resets
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Megatune flashes an RPM value once and resets
I am running Megatune 2.25 with 2.36 firmware. I am using MS2 v3 that I bought preassembled from diyautotune, and am using EDIS for the ignition. My problem is that when i try to start the car, MT briefly flashes 'cranking' and shows an RPM of about 111, then promptly switches to 'Not Ready' and 0 RPM. I have to power cycle MS to get it to show 'Ready' again. Can someone point me in the right direction? Thanks in advance for the help