Page 1 of 1
Datalogging config question
Posted: Fri Sep 08, 2006 5:05 am
by hobieboy
Hi,
I searched the forum & Megamanual but couldn't find the answer so please help...
Is there a way to configure what parm are being logged by MS (through MT logging full view)?
Also, my log for WBO2 shows up as volts. Is there a way for it to log it as AFR or lambda?
thanks.
Posted: Fri Sep 08, 2006 6:54 am
by jsmcortina
Open up the ".ini" file being used by Megatune (the one you activated) and scroll down to the end - this lists the parameters being logged.
James
Datalogging config question
Posted: Fri Sep 08, 2006 6:54 am
by jsmcortina
Open up the ".ini" file being used by Megatune (the one you activated) and scroll down to the end - this lists the parameters being logged.
James
------------------------
My Success story
http://www.msefi.com/viewtopic.php?t=8008
MS1/Extra at:
http://megasquirt.sourceforge.net/extra
----------------------------------------
This post is at:
http://www.msefi.com/viewtopic.php?p=141545#141545
----------------------------------------
Posted by email.
Posted: Fri Sep 08, 2006 10:04 am
by hobieboy
Thanks James... I looked at every other .inc thinking that it will be one of the "common" ones as opposed to Extra specific ones
Found it now
thanks.
Datalogging config question
Posted: Fri Sep 08, 2006 10:04 am
by hobieboy
Thanks James... I looked at every other .inc thinking that it will be one of the "common" ones as opposed to Extra specific ones
Found it now
thanks.
----------------------------------------
This post is at:
http://www.msefi.com/viewtopic.php?p=141570#141570
----------------------------------------
Posted by email.