Cannoct connect to FW v. 3.83
Posted: Tue Apr 21, 2015 7:08 am
I updated the firmware on my module OK. Now when I try to connect Tuner Studio (registered v. 2.6.14) it gives me a communication error. I was using a cheap USB to serial cable and the FTDI driver OK prior to this. It was picked up as COM 6, and when I ran Communications-Settings-Detect, my module showed up (as v. 3.83) like 3 times. When I tried to "Test Port", it failed no matter what the settings.
I then bought an express card serial adapter. It was recognized OK on COM 9. Same sequence, I can see the module during detection, but testing the port results in a failure, and I cannot connect to the module.
My laptop is running XP Pro SP3.
Any advice is welcome.
I then bought an express card serial adapter. It was recognized OK on COM 9. Same sequence, I can see the module during detection, but testing the port results in a failure, and I cannot connect to the module.
My laptop is running XP Pro SP3.
Any advice is welcome.