MicroSquirt.com read only forum (Jan.15,2018)

Speaking of surge tanks .

I've never been able to source the electrical isolated
connector to feed 12V to the pump inside .
I had to machine it myself .

Pat

Oh man , now after 25years of lpg experimenting , I finally find out about the existance of an lpg forum and it's already closed ??

What happend ?

Pat

Many volkswagen and audi cis cars had the to .
10cm long cilinder , made by vdo or bosch .

Pat

I've been experimenting with AG , Voltran and Keihin ( Prins/brc )

Keihins are the very best , but they are so da*mn expensive .

I've been told the new brc bottom feed's are pretty good ,ad reasonably priced , but I haven't had a chance to test them .

Other sources are bigas and romano but no ...

That's all very well and good. When you purchase a copy of Windows, do you consider that your intellectual property? Do you consider MegaTune to be your intellectual property? Do you consider the code running inside your MS your intellectual property? No, didn't think so.


Did you buy megatune ...

Switching can be doen "on the fly " .
I have a small pushbutton switch mounted on my dash .

Can even switch doing 160Kph on the highway .
Car doesn't even bump .

Look at this
http://megasquirt.sourceforge.net/extra/tableswitch.html
There's the table switchingfeature explained .

Thesame ...

I'm running an audi I5 for two years now with that setup ;

MS1 with the extra code

Petrol on inj channel 1
LPG on inj channel 2 .
An extra relay to cut power to the lpg inj when running on petrol .
Use the table switching option to switch between fuel and ign maps

Patrick

Brazing has the advantage that the solder or what's it called flows .
And it can be applied with little heat compared to welding , wich reduces
warpage . Also , it doesn't take to much skill to braze or solder .

Mag welding does takes some skill to get it all leak free .

An acetylene/oxygene ...

My first fuel rail was made of brass bungs , copper tube and silver solder .
It's been used for abt a year , then I changed it for an extruded aluminium one .
Not because it failed or leaked , but because it didn't look nice .
There must be some pictures of it in the succes stories .

As long as ...

Another way is to use a graduated cilinder with a small amount of soap water and an entrance on the side .
It takes some practise , but it's possible to create a kind of soap bulb that will move up in the cilinder as it gets filled wit gas troug the side entrance .

Pat