MicroSquirt.com read only forum (Jan.15,2018)

Yep, just open up TunerStudio, with the unit connected, and it should see all this. Browse to your ini, and you're good to go. :)

PS I put my download in the ecuDef folder within the config folder in TunerStudio, that way it'll always upgrade if I update another unit.
Oh nice; that had not ...

h22 wrote:I have a component built for the express PCB program, and its been verified, if anyone is interested.

Yes please!

It uses the Maxim 9926 two channel conditioning chip, and it is in A2 Mode. It can be modded (shunt resistor added via solder pad bridge) to suit different sensor permutations, and is a big improvement over the cased MicroSquirt circuit for me.

I don't know if this is like the MS2 Sequencer

V3.0 ...

Does this have the same VR input as the newest MS2Sequencer?

As I'm testing on a very similar setup as Scott, I thought I update here would be good. I've driven the car a lot since November. A few autocross event and even a short dyno session. I learned one thing: at least with my setup, I can't really run low z injectors in all types of driving. Street ...

I continue to daily drive the unit. Runs very well.

Note sure when more will be available.

http://www.youtube.com/watch?v=-mh004bKF3Q

Runs well enough I just left it in and autocrossed with it.

X-Tau turned on. Seems to work ok but maybe a little too much X in some places.

Very smooth.

Now running 3.610
I'll let Al explain the differences but it is much easier to set up and it runs very very well.
I'm impressed with the performance of the sequencer.

100mv is much too low, I believe.