C:\Megasquirt needed to be C:\MEGASQUIRT
Thanks!!!
MegaTune installation problems and cure
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
MoparKid1966
- MegaSquirt Newbie
- Posts: 1
- Joined: Thu Aug 04, 2005 3:17 pm
ERROR:megatune.ini:0040 - The included file 'MegaSquirt-II.ini' could not be opened.
MegaTune is terminating.
This is the error i get when trying to start megatune. Fresh installs on two separate computers with this same result.
I ran MegaTune configurator went to settings.ini >settings>CODE_VARIANT> and set it to MSII. I then saved and updated. Would not work...
*edit* I looked through the Audit.log and it was Opening the megatune.ini in C:\Program Files\MegaSquirt\MegaTune2.25\mtCfg which was then sarching for MegaSquirt-II.ini Which for some reason doesn't exist on a fresh install??
There are several similar files MegaSquirt-II.ini.1.0,MegaSquirt-II.ini.1.3,.......,MegaSquirt-II.ini.2.5 But these aren't recognized as ini type files. Any Suggestions?
**Nevermind
I got it. Was following directions here http://www.megasquirt.info/megatune.htm#install
After reading here http://www.megasquirt.info/ms2/configure.htm#install It works fine.
1966 Plymouth Sport Fury - Poly 318
15.39 @ 91mph
*coming soon* MS EFI
15.39 @ 91mph
*coming soon* MS EFI