I have the MS I v3.0 using the 2.25 software release. The system was originally installed using a NB O2 sensor, but I have recently switched over to the LC-1. I believe that I have completed the free air calibration correctly and made all the other switches in the software.
Here is the problem, the Megatune gauge indicates a Lambda value of .68 however the EGO LED display indicates full deflection of the green. The car is running very rich so I believe that the LEDS are ground truth. Any ideas on where I have made the error?
Also, if the car runs consistently too rich, can this damage the LC-1 sensor?
Thanks,
Jim
S.
lambda and EGO LEDS display opposite values
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.