starting issues

fast2300tbird · Post by **fast2300tbird** » Thu Aug 31, 2006 5:28 pm

I had the richen up my ve map alot to get it to run right. it runs great, but starts hard. It starts but then dies quickly. if I give it a little throttle to get it running it idles fine. but I have to crank with about 25 percent throttle to get it to start..

mops · Post by **mops** » Thu Aug 31, 2006 6:02 pm

several thing affect starting....

you didnt give much details.
like what ms you are using with whcih code. fuel or with spark ? crank trigger setup ? what warmup what afterstart settings ? it is only on cold or aswell on hot ?

you say it doesnt start.. it doesnt start at all or maybe it sputters once or more ? be more specific and descriptive.

lowest rpm/high map bins affect starting alot. i'd imagine these are set too rich...

CHB · Post by **CHB** » Fri Sep 01, 2006 12:14 am

i experienced the same problem too.. but i can't pressed on the throttle at all. have to crank the engine for at least 6 times without opening the throttle. the engine did started when i cranked it but dies immediately after that. after 5-7 tries, it can started on its own but once u step on the throttle, it will go died again. just leave it running in between "idling & dead" for couple of secs then only can step slightly on the throttle. but once the engine is warmed up, it start immediately when i crank it without a hitch. i'm wondering what is the problem too..
i'm running fuel only MSII on Ver3 board on Toyota 1800cc 3TC turbo.

fast2300tbird · Post by **fast2300tbird** » Fri Sep 01, 2006 4:49 am

msII/v3./tfi, the dist. is locked at around 20. ms is only doing fuel as of right now. I had to richen all the ve bins to get it to run right. I'm just going to play with it some more and see what I come up with i guess. I'll lean out the low ropm high map settings, I think thats the problem. thanx