Spare Output Variables

This forum is for discussion of MicroSquirt (TM) from Bowling and Grippo. The MicroSquirt information site is at www.usEasyDocs.com
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
herkamer
MegaSquirt Newbie
Posts: 12
Joined: Tue Nov 01, 2005 8:01 pm
Location: Lakewood, Colorado

Post by herkamer »

Thanks Al, much clearer now. So I should be using portStatus in my if/then statement rather than port0, port 1, etc., since this shows the status of all the ports combined?
Matt

80 Mustang Notch, 2.3T EFI, V3 MS2, 2.36FW, TFI, PWM IAC

Coming soon: 69 Dart Swinger 340, A500 OD MS2...hoping for 500hp!
Top
grippo
MegaSquirt Guru
Posts: 921
Joined: Mon Feb 16, 2004 6:55 pm

Post by grippo »

Yes you want to use port status.
Top
Post Reply

Return to “MicroSquirt General Information”