eliminating noise on TTL input
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
eliminating noise on TTL input
I'm guessing that this is probably a question for Bruce. Has any capacitance to eliminate back fed noise been included in the Microsquirt V2 board mods for the logic level outputs or will it have to be added to the signal wires as recommended in the LS1/LS2 coil page of the manual.