Hi!
After I installed a microsquirt/megasquirt on the third engine, I finally think I can give some suggestions to make wiring easier in future hardware versions:
There are still 2 Pins (PIN5, PIN18) left on the Superseal and this is how I would use them:
PIN5: MAP 5V
PIN18: Sensor Ground 2
The reason is that I have to split the 5V and the Sensor ground everytime I connect an engine because at least TPS and MAP definitly need a 5V connection and ground (Coolant also needs ground - but ok, we have no more Pins left). And even with rather professional crimping equipment it is still a pain to split wires into do and just looks ugly.
Maybe this can be done in future versions.
Thanks,
Johannes
Making wiring easier
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.