I updated the firmware on my module OK. Now when I try to connect Tuner Studio (registered v. 2.6.14) it gives me a communication error. I was using a cheap USB to serial cable and the FTDI driver OK prior to this. It was picked up as COM 6, and when I ran Communications-Settings-Detect, my module showed up (as v. 3.83) like 3 times. When I tried to "Test Port", it failed no matter what the settings.
I then bought an express card serial adapter. It was recognized OK on COM 9. Same sequence, I can see the module during detection, but testing the port results in a failure, and I cannot connect to the module.
My laptop is running XP Pro SP3.
Any advice is welcome.
Cannoct connect to FW v. 3.83
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Cannoct connect to FW v. 3.83
1981 Suzuki GS1000G
Adapting fuel injection mostly from a 2003 GSXR600 via a Microsquirt
Hearing "It can't be done" is SOP around here.
Adapting fuel injection mostly from a 2003 GSXR600 via a Microsquirt
Hearing "It can't be done" is SOP around here.
-
Matt Cramer
- Super Squirter
- Posts: 910
- Joined: Sat Jul 03, 2004 11:35 am
Re: Cannoct connect to FW v. 3.83
Can you upload a copy of the TunerStudioAppDebug.txt file?
Matt Cramer at DIY Autotune
