Hello,
I'm putting together a small block chevy and am wanting to use the Microsquirt setup. I'm planning on adding some boost to the engine. I'm wondering if it would be better to use an HEI 8-pin setup or would it be better to use a pro-billet type msd distributor and use the microsquirt to fire the coil directly if its even possible. Don't see a whole lot of info on it unless I am just looking in the wrong place.
Which setup to use?
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 910
- Joined: Sat Jul 03, 2004 11:35 am
Re: Which setup to use?
Current MicroSquirts do not fire the coil directly. You can use either one.
Matt Cramer at DIY Autotune
