I'm planning on using a GM mid 90's 8 cyl throttle body injected engine.
Question: does the microsquirt have enough outputs to support this engine?
Question: is there an application specific document for this project?
thanks.
GM TBI and microsquirt
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 910
- Joined: Sat Jul 03, 2004 11:35 am
Re: GM TBI and microsquirt
You'll need injector resistors to handle the low impedance injectors (the drivers will overheat and shut down otherwise; I've seen this happen before with a TBI and MicroSquirt), and you don't have any stepper IAC output. Other than that it can be, and has been, done.
Matt Cramer at DIY Autotune
