this might be a daft question ive looked at the manual, but how do you log the crank pick up teeth, the graphing and logging also the diagnostic and high speed logger tabs are greyed out.
Dan
tooth logging
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
LT401Vette
- Helpful Squirter
- Posts: 75
- Joined: Sat Jul 16, 2005 7:07 am
- Location: Charlotte, NC
- Contact:
Re: tooth logging
You must have Extra firmware or and MS3 for tooth logging.
Re: tooth logging
thankyou