Page 1 of 1
question about injector
Posted: Tue May 16, 2006 1:54 pm
by Seth23
hi, exept for the flow rate and that they are fitting in the hole, there is only 2 kind of injectors?(low and high impedance) so it doesn't matter where they do come from, i just have to know if they are low or high impedance and have the right flow rate?
Posted: Tue May 16, 2006 11:19 pm
by turbo355
You got it. You can check the resistance with a ohm meter to find out the impedence of the injector butt the flow rate is a little harder unless you know what they came out of or if you buy them new.
Posted: Wed May 17, 2006 10:05 am
by Seth23
nice, thx you very much