MicroSquirt.com read only forum (Jan.15,2018)

Ok i am trying to use the stock ignition setup on this motor do you think i can make it work, and if so what MS verison should i use

thanks
richie

This is a pretty traditional post and rotor type of ignition system... What's important is the signal that comes out of the wire to the ignition module. Neither the drawing or the schematic tell you that.

What you need to know is; is this ignition system triggered from that dizzy? If so, what is the triggering mechanism? (Points? Optical? VR sensor? Hall sensor?) Does the electronics in the dizzy control the coil directly or is there an external ignition module?

Also, please be specific about what car, engine, etc. this system comes from. The more you give the more you get!

-Brian

Looks like a toyota distributor. I bet it only has one tooth on the triger wheel ?

Later
Randy