Trigger sensor wiring on Yamaha RZ350/Banshee

Forum for discussing how to install MicroSquirt(TM), choose and troubleshoot sensors, wiring, and communications for MicroSquirt (TM) and MicroSquirt Module(TM).
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
sweet_baby_james
MegaSquirt Newbie
Posts: 1
Joined: Wed Oct 22, 2014 9:22 am

Trigger sensor wiring on Yamaha RZ350/Banshee

Post by sweet_baby_james »

I am about to start installation of an EFI setup onto my 85 RZ350. I am pretty comfortable with most of the steps (I am just using it for fuel control, not ignition at this point). However, I am getting stuck on how to wire up the pickup from the stock ignition system to the Microsquirt. I am using the stock CDI ignition that has two lobes on the flywheel and one pickup sensor. I an article http://www.smcomp.com/~smurph/RZ-EFI/install.html that uses an HEI module to make the stock sensor work, but this was not with the Microsquirt ECU, so im not sure if this is required.

If anyone has done this with their RZ350 or Banshee I would really appreciate some help.

Thanks

James
Top
Post Reply

Return to “Installation, Wiring and Sensors”