MicroSquirt.com read only forum (Jan.15,2018)

Any ideas? I'm still searching periodically, but haven't found anything

I've got some wierdness I'm trying to track down in the charger, and wanted to see if anyone here had any suggestions... Basically, the car is on a megasquirt V3 board, running MSnS-E 29q2, input direct from a locked MSD distributor VR sensor into the V3 board VR circuit. The output is driving an ...

Oh, forgot: better pic of the air temp sensor

Since I just finished doing it with PVC, I hope you're wrong :P

My oil pump is special order :( so I had time to work on the plumbing today :)

Basically it's just PVC wrapped in insulation, then wrapped again with duct tape. Still trying to think of a good way to make it look better, but function ...

Hm... Ok, I think I'm going to go with PVC, then. Should insulate a good bit naturally, I'll paint inside and wrap in some insulating tape I found recently, then paint the outside of that. I'm sure there's something I could wrap around the outside of the insulation to make it look better.

Of course ...

I've got one of the traditional circle-style air cleaners on my car right now, but I was goofing around and stumbled on this:

http://www.auto-nomics.com/cgi-bin/showresults?a=detail&part=11000
plus
http://www.auto-nomics.com/cgi-bin/showresults?a=detail&part=10247-003
plus
http://www.auto-nomics ...

In all honesty I can't say they are 'junk' - mine might have been a lemon. Plus, I've never dealt with the new ones...

But you know, a really bad experience makes a person not want to deal with a particular brand again...

Still, I'm just one person, there could be a lot of people who have good ...

I sent you a PM, so you know this much - but if you haven't already got a holley tb, I wouldn't really recommend it... I had all kinds of injector problems with mine... then they stopped manufacturing the injectors and replacing them would have cost nearly $500 (would have had to buy 4 new style ...

I've had my car running of the distributor timing for a while, and I'm about to go back to MS control. I've read through Lance's highly informative description of an initial map, and I think I'm pretty clear on it, but I wanted to post and see if anyone had any 'gotcha' type errors I should fix ...

Ok - I've been reading and reading, and since I'm finally starting to really look at the wideband o2 on my car, I generated a 'real' target afr table (instead of just 14.7's everywhere :P) Can anyone give me feedback on how this looks overall?
The engine is a mostly stock (internally) 70's era ...