I find repairing SMT stuff is often easier and quicker than through hole ... But you need good eyesight or a magnifier. Also, some of the codes and such on SM stuff are a bit cryptic, and therefore painful to work with. But anything SMT I have built looks shoddy compared with the same thing built by a machine!
I like Scotts idea - I put a standard V3.0 board in an Ford eec -4 case and it was a pain.
Kendall.
microsquirt purchase?
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
MegaScott
- MegaSquirt Guru
- Posts: 149
- Joined: Mon Jun 14, 2004 8:35 am
- Location: Seattle, Washington USA
- Contact:
Kendall,
Hopefully B&G can deliver a fully built unit without the connector I can use for the "Microsquirt inside" adaptor board. If I get one soon enough I'll bring a completed unit and a few adaptors to Brisbane the next time I'm out, probably the first of the year. I'll take the drive to Toowoomba and you can try it out on the 'Wagon.
Hopefully B&G can deliver a fully built unit without the connector I can use for the "Microsquirt inside" adaptor board. If I get one soon enough I'll bring a completed unit and a few adaptors to Brisbane the next time I'm out, probably the first of the year. I'll take the drive to Toowoomba and you can try it out on the 'Wagon.
